Master Bilt Master-Bilt IM-23GB Manuale Utente

IM-23GB Installation & Operations Manual With TLY 25 Controller Master-Bilt Products 908 Highway 15 North New Albany, MS 38

10ELECTRICAL CONNECTIONS The controller is provided with screw terminal block to connect cables with a cross section up to 2,5 mm2. Before connect

11TROUBLE SHOOTING Symptom-System Operates Long or Continuously Possible Problem Possible Cause Remedy How Long do the doors stay open? Door cl

12CABINET CLEANING PROCEDURES WARNING! To avoid electrical shock, disconnect main power supplies to the merchandiser be

13PARTS LIST PART DESCRIPTION IM-23 Condensing unit/1st run units 01-01733 Compressor (AEA44440YXA) 03-50330 Bottom Shelf 33-01453 Light Swit

14SALE AND DISPOSAL OWNER RESPONSIBILITY If you sell or give away your Master-Bilt Ice Merchandiser you must make sure that all safety labels and

15

2

3TABLE OF CONTENTS INTRODUCTION...

4INTRODUCTION Thank you for purchasing Master-Bilt Ice Merchandiser. This manual contains important instructions for installing, using, cleaning,

5NOTICE Read this manual before installing, cleaning, or performing any maintenance on your cabinet. Keep the manual and refer to it before doing

6MECHANICAL Remove front grille and check refrigeration lines to see that they are free (not touching each other or compressor). Spin condenser f

7MICROPROCESSOR-BASED DIGITAL ELECTRONIC FREEZER CONTROLLER 712 136511 89103412Aux-OK+Fan AuxDefOutALTLY 25 1 - Key P: Used for setting the Set p

8OPERATION Fan The fan will run constantly except when a defrost is initiated, or when the evaporator temp is above 35oF. When in defrost mode th

9LIST OF PARAMETERS Here is a list of factory set parameters the value of which can not be change in the field without the password. Symbols